![]() ![]() If the voltage reaches the 12-volt range, the wall plate is functioning, but the antenna head’s amplifier likely is not. Should you not find any corrosion, grab a 12-volt DC test light or DC voltmeter to determine the voltage of the coax cable.If there is, replace the cable, and possibly the connection on the antenna, depending on the situation. Examine the connections for the coax cable to see if there is any corrosion.We suggest you don’t do this without at least one other person around so they can get help if needed. Be careful climbing up onto the roof of the RV. Find the coax cable and disconnect it from the head of the antenna.Some antennas will automatically turn this off when not in active use, requiring you to flip it back on when needed manually. Take a second to ensure that the amplifier switch is still in the on position.At this point, you can replace the cable or try our second guide, found below. After checking the cables and turning on the amplifier, you may find that you still don’t have signal.Check to see if it’s off if it is, turn it on and check the signal. This usually is on the wall plate that the wires run through. Should there be no issue with the wires, move to the amplifier.For example, tighten loose connections or replace cables that are cracked. These include loose connections, cracked wires, and knots. If others have signal, start by examining all the cables that run to the antenna for any apparent issues. ![]() If they are, the problem may be with the signal in the area, not your antenna.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |